Siemens Deka 220 lb/hr Fuel Injectors Part # 110333 or FI114212
Low Impedance with EV1 Plug.
For use with all gases, methanol, ethanol & racing fuels!!!
These are priced per injector.
These are a perfect fit for all 2 rotor, 3 rotor, 4 cylinder, 6 cylinder & 8 cylinder applications!!!
All Paradise Racing Injectors are tested, flowed & balanced in house on our New Age NA4DFV Injector Flow Bench.
--
220 lb/hr Siemens Deka Fuel Injectors Part # 110333 or FI114212
Low Impedance Gas & Flex Fuel Injectors
(Long Style) EV1 Connector
Part Number: 110333 or FI114212
Genuine Siemens DEKA IV Mototron 220 lb/hr Low Impedance Gas & Flex Fuel Injectors ( Long Style )
These injectors flow 220 lbs/hr at 43.5 PSI ( 3 BAR ) and more at higher PSI! These units are low-impedance and require peak and hold injector drivers or additional resistors for saturation drivers. Despite the high flow rate, they are linear and controllable at low pulse widths compared to other extreme flow injectors! These injectors are sometimes referred to as 212lb/hr or 225lb/hr injectors.
These injectors will allow you to run methanol, ethanol and other flex fuels with fewer injectors for high horsepower applications. Don't settle for questionable modified high flow injectors when you can have Genuine Siemens quality and performance with these injectors. These injectors are perfectly suited for Extreme horsepower turbo & supercharger applications.
Features:
Genuine, reliable Siemens Injectors
Excellent response characteristics
Robust Design
Low Impedance
Fits in most Deka I, Deka IV Long Style, Deka V Long Style, & Deka VII Long Style applications
Specifications:
Coil Resistance: 2.27 Ohms / Low Impedance / Low-Z (ECM peak & hold driver or modifications required)
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 220 lb/hr = 2433 cc/min
Offset: 0.64ms
Turn on time: 1.5ms
Turn off time: 1.3ms
Connector: Bosch EV1
Series: DEKA 4 ( DEKA IV )
Orifice Type: Single Orifice
Spray Pattern: 10-15 Degree Pencil Cone
Factory fitted with Viton upper and lower o-rings
Offset/dead time table:
2.143 ms, 8 volts
1.830 ms, 9 volts
1.607 ms, 10 volts
1.473 ms, 11 volts
1.339 ms, 12 volts
1.384 ms, 13 volts
1.295 ms, 14 volts
1.250 ms, 15 volts
1.161 ms, 16 volts
1.071 ms, 18 volts
Minimum Pulse Width: 2 ms
Opening/Closing:1.5 ms/1.3 ms